The SPS-T-SC1 turbidity/suspended solids (sludge concentration) sensor is a
turbidity and suspended solids sensor based on the 90° and backscattered light
measurement principle. Mainly used in the fields of surface water, domestic
sewage and industrial sewage. The turbidity sensor is equipped with automatic
optical window cleaning function. In addition, with the MC-W-S series controller
and SPS-Server (SPS cloud service), users can realize on-site and remote data
viewing.
The SPS-T-SC1 sensor adopts the principle of scattered light measurement.
The 860nm laser light source emits light, the 90° detector receives the light
scattered by the suspended matter in the water and generates a signal, and the
detectors at other point angles receive signals from other angles. According to
the proportional relationship between the two angle signal values and the
concentration of suspended solids in the water body, the turbidity and
suspended solids concentration of the water body can be calculated.
Installation of SPS-T-SC1
Submerged installation
The sensor is mounted with a bracket.
Pipe installation
This method of mounting the sensor is recommended for main pipe sizes
larger than 150 mm.
Flow-through installation
The flow cell is symmetrical, so please install it vertically and make sure that the water
flows in from the bottom and out from the top to ensure that the water flow fills the flow
cell.
Thread the limiter, locking ring, and union nut through the end of the sensor in sequence
as shown in the figure.
Shield unit install
When installing the sensor in a bright light environment, such as outdoors, it is
necessary to install a shield unit to block the effects of bright light on the sensor
measurement.
SPS-T-SC1 Turbidity/Suspended Matter (Sludge Concentration) Sensor